Changes between Version 16 and Version 17 of EGIISIntegration

Timestamp:

03/17/14 13:17:30 (10 years ago)

Author:

bartek

Comment:

--

EGIISIntegration

@@ -2 +2 @@
 The basics of EGI Information Service are described at [[http://gridinfo.web.cern.ch/introduction|link]].
 
-In general, information about a grid service is produced by a service provider and transfered into the closest BDII (LDAP) instance (typically co-allocated with the service).This procedure is significantly simplified with the help of tools offered by EMI Resource Information Service (`emi-resource-information-service`). Consequently, the integration of new services was limited to the provisioning of a few script and configuration files. In case of QCG-Notification, the required stuff is distributed within the package: `'''qcg-ntf-egi-is-provider'''`, available for SL5 and SL6.
+In general, information about a grid service is produced by a service provider and transfered into the closest BDII (LDAP) instance (typically co-allocated with the service).This procedure is significantly simplified with the help of tools offered by EMI Resource Information Service (`emi-resource-information-service`). Consequently, the integration of new services was limited to the provisioning of a few script and configuration files. In case of QCG-Notification, the required stuff is distributed within the package: '''`qcg-ntf-egi-is-provider`''', available for SL5 and SL6.
 
 == Requirements ==
@@ -21 +21 @@
 
 == Installation ==
-The installation of QCG-Notification provider for EGI IS may be done simply by installing the `'''qcg-ntf-egi-is-provider'''` RPM:
+The installation of QCG-Notification provider for EGI IS may be done simply by installing the '''`qcg-ntf-egi-is-provider`''' RPM:
 {{{
 yum install qcg-ntf-egi-is-provider
@@ -27 +27 @@
 
 == Configuration ==
-All the QCG EGI IS providers depend on the `'''qcg-egi-is-conf'''` package that is used for configuration of common data for all QCG services installed on the same resource. After the first installation of `qcg-egi-is-conf`, the installator will ask for configuration of the `'''site-ID'''`:
+All the QCG EGI IS providers depend on the '''`qcg-egi-is-conf`''' package that is used for configuration of common data for all QCG services installed on the same resource. After the first installation of `qcg-egi-is-conf`, the installator will ask for configuration of the '''`site-ID`''':
 
 {{{
@@ -36 +36 @@
 }}}
 
-According to this information, the requested data may be established with help of `'''qcg-info-site-config'''` command:
+According to this information, the requested data may be established with help of '''`qcg-info-site-config`''' command:
 {{{
 qcg-info-site-config -s PSNC